Picked my car up from the garage and all my windows worked that day along with my power lock. The next day went to roll down window on drivers side, and it wouldn’t roll down. Tried to roll other windows down and none of them would work, then also noticed the power lock on the driver’s side doesn’t work as well. Find it very odd that all four windows stopped working at the same time.
Odpovědi 12
TransAm77 odpověděl před 8 lety
Its in the drivers master switch or the wiring in between the he door and the body in the rubber boot. What kind of work was done while it was at the garage?
17 lidem to pomohlo.
ThatGuyDuncan answered 8 years ago
Did you resolve? How? I’m in the same boat, would love to fix. Thanks!
4 lidem to pomohlo.
Terry odpověděl před 7 lety
I know this is pretty much dead but this is still happening to people. I work at a shop and had one of these things come in just recently. after going through just about everything, i decided to check wire continuity to each wire going into the door. Long story short, I think the window on this thing hits the main wire harness that comes into the door. It’s popped out of the normal holder that holds it to the door and the MAIN ground wire was literally pulled in half right in the rubber boot between the car and door. Run a new main ground wire (large guage black wire on the window switch connector) from inside the car to inside the door to the connector on the window control switches. Make sure to route it AROUND the window track as i think this was the issue in the first place and everything should go back to normal. One more thing, I don’t recommend grounding directly to the door as it doesnt seem to have a good ground. Grounding directly does work but you would probably have to ground the door to the normal frame to get a good enough ground for it to work. Good luck and hope this helps.
22 lidem to pomohlo.
John odpověděl před 6 lety
Well I just fixed mine today with almost the same problem. Locks and Power Mirror worked I couldn’t raise or lower any window from the Master Power Window switch on the drivers door. Trouble shot all the circuits and found no power getting from the Power Window relay to the door Master switch. Turns out the power wire had broken between the door and body in the rubber boot. I took the door off and checked the harness, glad I did, besides a completely broken power wire 5 other wires were cracked and would be breaking soon. I spliced and soldered in 6 wires total. Everything works fine now but what upsets me is that my Endeavor is a 2011, only 6 years old. Cheap and brittle wire I guess.
11 lidem to pomohlo.
Guru5P91M answered 5 years ago
Terry was right on the nose with my problem. Black ground wire broken in between door and main body. A real pain to fix that took me about 3 hours to locate the break and snake a wire in for splicing, but it’s done and I’m happy.
4 lidem to pomohlo.
Spinnr3 answered 5 years ago
I kind of have the same problem, when I try to lower the window all I get is a buzzing sound on the rivers window switch. Cannot roll any windows down from any switch, even the actual back door switches don’t work. Would the above fix also work for my issue?? Any help would be appreciated.
1 lidem to pomohlo.
GuruY3Z6X answered 5 years ago
oh my — this just happened to my endeavor last week. Guess I»m taking it in to fix since it sounds complicated
2 lidem to pomohlo.
Samhowery1 answered 5 years ago
Mine sounds a little different , ? my power locks work , but all ‘4’ windows will not go down or up unless the driver door is wide open, than they work fine .. any thoughts all??
2 lidem to pomohlo.
GuruWWMQC answered 5 years ago
Mark, Same happened to mine, it’s the wiring harness. UGH Mitsubishi charged me 432.00 USD to replace and they work fine now. PS: my car was only 6yrs old.
5 lidem to pomohlo.
Samhowery1 answered 5 years ago
Can you tell me exactly the Wiring harness name, so I can get it ordered??
2 lidem to pomohlo.
Spinnr3 answered 5 years ago
All they wrote on the invoice was wiring harness. Look up JC Whitney, they have all the parts, just elect your vehicle and search parts
2 lidem to pomohlo.
RickRam88 answered 3 years ago
Thanks for the comments! My ‘05 Endeavor had 3 broken wires on driver side door, one was the ground, other two were windows. After splicing the cables with new extensions, everything worked fine. I did have to remove door, door cover, unplug lock and window connectors, to reach the rubber sleeve that cover the wires entering door. I was going to run a new ground cable to at least get locks to work but in the process of taking parts apart I found the broken wires inside the rubber sleeve. Thanks again for the solution.
2 lidem to pomohlo.
Tvoje odpověď:
Související otázky
All four of my windows stopped working and the power lock on the driver side as well. 12 Answers
Picked my car up from the garage and all my windows worked that day along with my power lock. The next day went to roll down window on drivers side, and it wouldn’t roll down. Tried to roll other win.
2004 Mitsubishi Endeavour LS AWD — Údržba a opravy
How to get the Driver side power window switch working 5 Answers
The power window switch on the driver door stopped working. All the other door switches work and the fuse is good.
2007 Mitsubishi Endeavor SE — Maintenance & Repair
2004 Mitsubishi Endeavor all 4 windows stopped working.. 1 Answer
My windows are all halfway down in Colorado in October. None of the switches work on the drivers side and back doors. All my fuses and relays are good. The only switch that works is the passenger.
2004 Mitsubishi Endeavour XLS — Údržba a opravy
in my 06 endeavor i hear whooshing sound when I have my AC on and water leaking inside on my passenger and driver side 1 Answer
Anytime I have my AC on and I’m turning either direction there is a whooshing sound/water sound..sounds like it is in my dashboard. water leaks mainly on passenger side and sometimes can feel it on .
