To start your engine with a booster battery, the instructions and precautions below must be followed.
If the battery of a vehicle equipped with the NISSAN Intelligent Key ™ is discharged, the ignition switch cannot be moved from the LOCK position, even using the mechanical key or the valet key. Connect the jumper cables to another vehicle, as in the case of a discharged battery, and then the ignition switch can be moved from the LOCK position.
Then, jump start the vehicle.
● If done incorrectly, jump starting can lead to a battery explosion, resulting in severe injury or death. It could also damage your vehicle.
● Explosive hydrogen gas is always present in the vicinity of the battery. Keep all sparks and flames away from the battery.
● Do not allow battery fluid to come into contact with eyes, skin, clothing or painted surfaces. Battery fluid is a corrosive sulfuric acid solution which can cause severe burns. If the fluid should come into contact with anything, immediately flush the contacted area with water.
● Keep battery out of the reach of children.
● The booster battery must be rated at 12 volts. Use of an improperly rated battery can damage your vehicle.
● Whenever working on or near a battery, always wear suitable eye protectors (for example, goggles or industrial safety spectacles) and remove rings, metal bands, or any other jewelry. Do not lean over the battery when jump starting.
● Do not attempt to jump start a frozen battery. It could explode and cause serious injury.
● Your vehicle has an automatic engine cooling fan. It could come on at any time. Keep hands and other objects away from it.
● If the battery of a vehicle equipped with the Intelligent Key system is discharged, the ignition switch cannot be moved from the LOCK position, even using the mechanical key or the valet key. Connect the jumper cables to another vehicle, as in the case of a discharged battery, and then the ignition knob can be moved from the LOCK position.
Then, jump start the vehicle.
1. Pokud je pomocná baterie v jiném vozidle, umístěte obě vozidla tak, aby byly jejich baterie blízko sebe.
Do not allow the two vehicles to touch.
Always follow the instructions below.
Failure to do so could result in damage to the charging system and cause personal injury.
2. Apply the parking brake. Move the shift selector to N (Neutral) (manual transmission) or to P (Park) (CVT). Switch off all unnecessary electrical systems (lights, heater, air conditioner, etc.).
3. Remove the vent caps on the battery (if so equipped). Cover the battery with an old cloth to reduce the explosion hazard.
4. Connect the jumper cables in the sequence illustrated ( A , B , C , D ).
● Always connect positive (+) to positive (+) and negative (-) to body ground (for example, strut mounting bolt, engine lift bracket, etc.) — not to the battery.
● Make sure the jumper cables do not touch moving parts in the engine compartment and that the cable clamps do not contact any other metal.
5. Nastartujte motor pomocného vozidla a nechte jej několik minut běžet.
For Intelligent Key system equipped models, use the mechanical key to start the engine.
6. Keep the engine speed of the booster vehicle at about 2,000 rpm, and start the engine of the vehicle being jump started.
Nenechávejte startér zapnutý déle než 10 sekund. Pokud motor nenastartuje ihned, přepněte spínač zapalování do polohy OFF a počkejte 3 až 4 sekundy, než to zkuste znovu.
7. After starting the engine, carefully disconnect the negative cable and then the positive cable.
8. Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes, as it may be contaminated with corrosive acid.
Viz také:
Používání systému
The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given t .
Rear-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint .
Compact Disc (CD) player operation
Place the ignition switch in the ACC or ON position, and insert the CD into the slot with the label side facing up. The CD will be guided automatically into the slot and start playing. After lo .
